To Next Page

To Previous Page

Maintenance and

Disassembly

 Page 77 

Procedure Illustration

3) Remove the hex nuts and washers securing

the compressor, located on the bottom

plate (see CJ_ODU_019).

4) Heat up the brazed parts and then remove

the the discharge pipe and the suction

pipe (see CJ_ODU_020).

5) Lift the compressor from the base pan

assembly with pliers.

CJ_ODU_019

CJ_ODU_020

Note: This section is for reference only. Actual unit appearance may vary.

Discharge Pipe

Suction Pipe

York YUFE60BYTM-MS-1 User Manual

Questions and Answers: