Need help?Do you have a question about the YORKVILLE PULSE PS210P and is the answer not in the manual?
General| Type | Powered Subwoofer |
|---|---|
| Woofer Size | 10 inch |
| Frequency Response (+/- 3dB) | 45Hz - 100Hz |
| Impedance | 8 Ohms |
| Enclosure Type | Bass Reflex |
| Amplifier Power | 1200 Watts Program (2400 Watts Peak) |
| Driver Size | 10 inch |
| Input Connectors | XLR |
| Max SPL | 133dB |
Covers risks of electric shock, fire, and injury; do not open, refer to qualified personnel.
Includes reading manual, proper packaging, power sources, hazard avoidance, and service guidelines.
Selects input signal level between Speaker and Line; use Line only with active crossover below 125 Hz.
Manages ground connection to prevent hum; use GND position when source lacks ground pin.
Electronically boosts low frequencies and adjusts output to prevent distortion and speaker damage.
Adjusts subwoofer bass level for desired system mix; set at medium levels, not high.
Allows connection of multiple PS210Ps in parallel via PARALLEL THRU jacks for expanded bass.
Refers to user notes on the rear panel, reprinted for convenience on the following page.
Provides instructions for connecting the PS210P to full-range speakers and audio sources.
Details the use of the built-in stand mounting adapter with specific cabinets and limitations.
Describes various system configurations, including stereo, mono, and multiple subwoofer setups.
Instructions for plugging in the AC cord and ensuring proper ventilation for the unit.
Guide for connecting to mixer/amplifier line-level outputs using shielded patch cords.
Guide for connecting to speaker outputs or in parallel with full-range speakers.
Instructions for linking multiple PS210Ps or other powered speakers using PARALLEL THRU jacks.
How to adjust the PS210P's LEVEL control for optimal sound mixing with full-range speakers.
Guidance on replacing blown fuses and identifying potential AC line voltage issues.
Advice on preventing low-frequency feedback when the unit is left powered on after amplifier shutdown.
Details voltage and VA ratings for North American and European power sources.
Lists internal amplifier power output and input impedance details.
Specifies the number, size, impedance, and power handling of the unit's drivers.
Provides information on maximum SPL and frequency response range.
Details the type and configuration of input and output connectors.
Explains the grounding mechanism, including the GROUND LIFT switch and protection device.
Lists the parameters controlled by the unit's limiting circuitry.
Provides the physical specifications for the subwoofer unit.
To Next Page