Adjustment method: When the power is turned off, take a 5mm hexagonal
wrench, turn the adjusting bolts on the left side ¼ turn clockwise, and then
power on the machine to run, and the test running belt is centered. Proceed in
this way until the loose adjustment of the walking belt is centered.
◆ The running belt deviates to the right
Adjustment method: When the power is turned off, take a 5mm hexagonal
wrench, turn the adjusting bolts on the left side ¼ turn clockwise,and then
power on the machine to run, and the test running belt is centered. Proceed in
this way until the loose adjustment of the walking belt is centered.
◆
The running belt will be loose after using for a period of time, the
running belt is too loose, the running belt will slip when using.
Adjustment: In the state of power off, take a 5mm hexagonal wrench, turn the
left and right bolts of the rear roller to the right 1/4 turn at the same time to
tighten the running belt, and then power on the machine to run and test the
tightness of the running belt. This method until the running belt tightness is
appropriate.
Note: When you use the treadmill, due to the running of the two feet with the
same force is not as large, the pressure on the running belt is not balanced,
resulting in the running belt deviated from the center. This deviation is normal,
when no one is running on the running belt, it will return to the center.
The running belt should not be adjusted too tightly. This will pull the running
belt, increase the pressure on the front/rear drums, bring harm to the drum
bearings, etc., and produce noise or other problems.
To Next Page
Loading...