2. Lubricating oil for walking machine
The machine is pre-lubricated before leaving the factory. With use, the belt
running deck will become dry gradually and the fiction between the belt and
deck will increase, which may wear both the deck and the belt. Proper belt
lubrication will help keeping your treadmill in its best condition. We recommend
you to lubricate your treadmill once every 30 hours in use.
Note: Please use special lubricants for treadmills or contact our
company directly.
How to add lubricant to the treadmill:
Turn off the power switch and unplug the power plug. The place to lubricate is on
the lower surface in the middle of the running belt. (As shown below)
Cut the mouth of the oil bottle into a small mouth, not too large, but to be
able to inject.
Lift the running belt so that the oil bottle is extended to the bottom of the
running belt, inject the oil into the middle of the running board, and lower
the running belt.
Plug in the power plug and turn on the power switch. After turning on the
machine, wait one minute for the oil to be applied evenly and then use
the treadmills.
Note: Attention should be paid to safety during lubricating operations.
To Next Page
Loading...