http://www.ysvacuumsealer.com
How to Make Custom Sized Bags
1. Pull enough bag material to hold item to be vacuum packaged, plus
2 inches. With a pair of scissors or sharp knife, cut desired bag
length from bag roll. Make sure to cut in a straight line. Plug in
power cord.
2. Open lid. Place one end of cut bag onto sealing bar, please make
sure this end is not on or inside the sealing foam ring area.
3. Close lid by pressing down on both sides. Now keep pressing until
the goes off or you can use your left thumb to press the seal button
SEALING BAR
Do not tear the high-temperature resistant tape away.
SEALING FOAM RING
Make sure the open end of bag is inside this area when
vacuumizing.
CIRCUIT SWITCH
When the lid touches this switch, the machine starts to
vacuummizing. Please do not touch this switch when the lid is
open.
To Next Page
Loading...