Air Filter Regulator
YT-200 / 205 / 220 / 225 series Product Manual
Ver. 1.01 3
1. Introduction
1.1 General Information for the users
Thank you for purchasing Young Tech Co., Ltd products. Each product has been fully
inspected after its production to offer you the highest quality and reliable performance.
Please read the product manual carefully prior to installing and commission the product.
➢ The manual should be provided to the end-user.
➢ The manual can be altered or revised without any prior notice. Any changes in
product’s specification, design, and/or any components may not be printed immediately
but until the following revision of the manual.
➢ The manual should not be duplicated or reproduced for any purpose without prior
approval from Young Tech Co., Ltd, Gimpo-si, South Korea.
➢ In case of any other problems that are not stated in this manual, please make immediate
contact to Young Tech co., Ltd.
1.2 Manufacturer Warranty
➢ For the safety, it is important to follow the instructions in the manual. Manufacturer will
not be responsible for any damages caused by user’s negligence.
➢ Any modifications or repairs to the product may only be performed if expressed in this
manual. Injuries and physical damages caused by customer’s modifying or repairing the
product without a prior consultation with Young Tech co., Ltd will not be compensated. If
any alterations or modifications are necessary, please contact Young Tech Co., Ltd
directly.
➢ Standard type with NBR rubber (ambient temperature range option 1) is subject to
damage by ozone. If you suspect that ozone may be present at the site or if supplied air
is likely to contain ozone, select a high temperature version (ambient temperature range
option 2) or a low temperature version (ambient temperature range option 3) with
SILICONE rubber.
➢ Manufacturer warrants the product from the date of original purchase of the product for
eighteen (18) months, except as otherwise stated.
➢ Manufacturer warranty will not cover products that have been subjected to abuse,
accidents, alterations, modifications, tampering, negligence, misuse, faulty installation,
lack of reasonable care, repair or service in any way that is not contemplated in the
documentation for the product, or if the model or serial number has been altered,
tampered with, defaced or removed; damages that occurs in shipment, due to act of
God, failure due to power surge, or cosmetic damage. Improper or incorrectly
performed maintenance will void this limited warranty.
➢ For detailed warranty information, please contact the corresponding local Young Tech
Co., Ltd office or main office in South Korea.
To Next Page
Loading...
Need help?
General
