Yudian AI-501 - Technical Specification; Input Type; Measurement Range; Measurement Accuracy

 Yudian(H.K.)AutomationTechnol o gyCo.Ltd.
Website:http://www.yudian.ushttp://www.yudian.com.hk
Email:sales@yudian.com.hk
Tel:+852‐27708785Fax:+852‐27708796

5

TECHNICAL SPECIFICATION:
● Input type :
Thermocouple: K, S, R, E, J, N
Resistance thermometer: Pt100, Cu50
Linear voltage: 0～5V, 0～1V, 0～500mV, 0～100mV, 0～60mV, 0～20mV, 100～500mV, 0～10V, 0～20V,
Linear current (should connect a external resistor or install I4 module in MIO slot): 0～20mA, 4～20mA
Linear resistor: 0～80 ohm, 0～400 ohm
Alternating current: 0～5A
Alternating voltage: 0～500VAC
● Measurement range :
K(0～+1300 ), S(0℃ ～1700 ), R(0℃ ～1700 ), E(0℃ ～1000 ), J(0℃ ～1200 ), N(0℃ ～1300 ),℃
Pt100(-200～+800 )℃ , Cu50(-50～+150 )℃
● Linear input :
-9990～+30000 unit defined by user
● Measurement accuracy :
0.3%FS±1
● Temperature display resolution :
0.1 for K, E, J℃ , N, Pt100 and 1 for S, R℃
● Temperature shift :
≤0.015%FS/ (typical value is 75ppm/ )℃℃
● Electromagnetic compatibility (EMC) :
IEC61000-4-4, ± 4KV/5KHz; IEC61000-4-5, 4KV
● Retransmission :
When X3 or X5 current module is installed in OUTP slot, process value (PV) can be retransmitted to standard
current with maximum load resistor 500 ohm.
● Alarm function :
High limit, low limit, second high limit and second low limit
● Isolation withstanding voltage :
Between power, relay contact or signal terminals ≥2300VDC; between isolated electroweak signal
terminals≥600VDC
● Power supply :
100～240VAC, -15%, +10% / 50-60Hz; 24VDC / AC, -15%, +10%
● Power consumption: ≤5W
● Operating Ambient :Temperature -10～+60 ; humidity ≤90%RH℃
● Front panel dimension: 96×96mm, 160×80mm, 80×160mm, 48×96mm, 96×48mm, 72×72mm, 48×48mm
● Panel cutout dimension: 92×92mm, 152×76mm, 76×152mm, 45×92mm, 92×45mm, 68×68mm, 45×45mm
● Depth behind mounting surface: ≤100mm