.8.
Remote Control ( Emitter ) Operation
3
4
5
6
1
2
1H 3H
6H
Fan Speed
(1/2/3/4/5/6)
Fan Off
Fan Timer Switch
(1hr,3hr,6hr)
Light brightness “+/-”
Forward/Reverse
LED On/Off
Colour Change
-
+
Transmitter FunctionRemote Control Holder
Installation
②
③
⑤
⑥
④
①
AAA 1.5V
Press and hold
for about 3 sec
1.Insert the 2 pcs of batteries into
transmitter.
2.Turn on the power supply to the fan.
Within 10 sec, press and hold the “1”
and “2” button for about 3 sec. Once
the receiver has detected the frequen-
cy, receiver will “Beep Beep” twice.Pro-
gramming process is completed and fan
is ready to use.
Transmitter learning
process
NOTE:The remote control device has already been
code matching when it leaves the factory.If the fan is
not responding to the transmitter,repeat transmitter
learning process.
Visit www.pmwfan.com
for further assistance.
To Next Page
Loading...
