YuJet Surfer - BATTERY STATUS AND RIDING MODES

The YuJet baery has a set of LED lights on the top of
the baery for easy viewing while riding. These LEDs
indicate the baery level and acvaon. If these lights
turn on the baery is acvated and will display the
remaining baery level.
The LED and baery acvaon will turn off if le
unaended for a length of me. To reacvate the
baery, remove the safety magnet, wait for a few
seconds, then place the safety magnet back onto the
baery.
LED Indicaons
Wrist Strap: The wrist strap must be used at all me
while operang the YuJet personal watercra. In the
event of a fall the wrist strap prevents the remote from
being thrown out of reach of the user. The remote is
fully waterproof and will float in case the wrist strap
breaks.
The YuJet PWC has two modes of operaon. Out of the
box your YuJet personal watercra will be set to
beginner mode. At any me, the user can change from
either mode by tapping the power buon 3 mes. Your
board will remain in that mode unl you choose another
mode.
Beginner mode: (Blue BEG indicaon) is designed to
have a smooth power curve and limited maximum
speed. This is perfect for the new user, or the user wants
to conserve baery power for longer rides.
Expert Mode: (Orange EXP indicaon) unleashes the full
potenal of the YuJet personal watercra. This mode
gives you the most amount of acceleraon and top end
speed. This mode is great for the experienced rider with
speeds up to 25 mph. (speed is dependent on rider
weight and water condions)
4: The baery is acvated by adding the safety magnet
to the contact area. The LED baery status indicator will
light up and remain on showing the level of baery
power.
5: Secure the latches by turning them 180º and lowering
the tabs. If you find it difficult to turn the tabs, press
down or tap the top of the baery unl the latches are
free to turn.
BOARD SETUP
BATTERY STATUS
REMOTE OPERATION
BEGINNER AND SPORT MODE
INSTALLING THE BATTERY
5% 25% 50% 75% 100%