YuJet Surfer - BOARD SETUP INSTRUCTIONS; Installing the Leash; Installing the Fins; Installing the Battery

1: Place the Velcro through the string and pull the leash
so the knot is at the boom of the first Velcro pocket.
1: Remove the fins from the protecve pouch. You will
have two le and two right fins.
2: Slide the front of the fin into the fin box. Making sure
that the fork cradles the locking pin.
3: Rotate the fin unl the fin is completely set into the
fin box. Powerful magnets help hold the fin in place, and
make for easy installaon and removal.
1: Insure the baery latches are in the open posion
with the tabs straight up.
2: Make sure the baery safety magnet is removed from
the baery.
3: Lower the baery into the cavity.
Oponal: A locking set screw and key is provided if you
wish to lock your fins to your YuJet suroard. To lock
your fins to the board simply screw in the setscrew with
the provided key unl you feel a resistance. This is
usually about 4-5 turns of the key.
3: To install the leash on your ankle, choose your rear
foot and open up the Velcro. Put the leash line towards
the back of your foot. Seal the Velcro to finish.
Note: The leash is equipped with a small pocket to keep
your vehicle key in while using the YuJet.
2: Fold the Velcro so the knot is capture in the middle
and then seal the rest of the Velcro tabs as pictured
above.
BOARD SETUP
INSTALLING THE LEASH INSTALLING THE FINS INSTALLING THE BATTERY