Page 8 For technical questions, please call 1-888-866-5797. Item 58832
SAFETY OPERATION MAINTENANCESETUP
20. With the felt side up, slide a Drawer Bottom
(13) into the grooves along the insides of the
assembled Left and Right Drawer Slot Panels
from the previous Step. Fasten a Drawer Back
Panel (10) to the ends of the two Slot Panels, then
fasten Drawer Bottom to Drawer Back Panel.
Drawer Bottom (13)Drawer Bottom (13)
Drawer Slot Drawer Slot
Panel (11,12) Panel (11,12)
Drawer Back Drawer Back
Panel (10) Panel (10)
21. Repeat Steps 19 and 20 for the bottom
drawer. Once Drawer is fully assembled,
verify that the inside tracks along the Legs
and Sliding Partition are pushed forward.
22. Slide Drawers into tracks along Sliding
Partition and insides of the Legs.
Drawer Front Drawer Front
Panel (9) Panel (9)
23. Once all Drawers are inserted, tap Wood
Pegs (19) and Anvil Pegs (20) into
desired holes on the Table Top.
Wood Pegs (19) Wood Pegs (19)
Anvil Pegs Anvil Pegs
(20) (20)
Table Top (2) Table Top (2)
The Workbench is now fully
assembled and ready for use.
To Next Page
Loading...
