Skip
The Skip function is used during scan and search modes to prevent the radio from stopping on any one
frequency for an undue amount of time.
Normally, when scanning or searching comes across an active transmission it will stop on that frequency
until the transmission ceases and then resume scanning/searching. For some situations, staying on one
frequency for too long may miss transmissions occurring on other frequencies.
When the Skip function is enabled, if the scan or search operation stops on an active transmission, it will
resume the scan/search when the transmission ends or five seconds have elapsed; whichever occurs first.
To enable Skip
1. Press FUNC + SKIP
2. The SKIP indicator appears
To disable Skip
1. Press FUNC + SKIP
2. The SKIP indicator disappears
NOTE : The Skip function has no effect on active priority channel signals.
Acknowledgment
Many thanks go to those who have helped me to improve this guide by providing corrections and other
feedback!
Mark Ansel
Last updated June 23, 1999
Copyright 1999 by Richard J. Wells
To Previous Page
Loading...
General