Z-CAM Z CAM E2C - 5.2. Ethernet Connection

4. Connect to the camera from the iOS device or a computer with that Wi-Fi ID, and
the default password of the Wi-Fi is 12345678. (not changeable for now)
5.2. Ethernet Connection
There are 2 options to connect the camera to a computer through Ethernet: Direct
Connection or Connection through a Router:
Direct connection
Follow the steps below to set up direct Ethernet connection between the camera and the
computer:
1. Set the Network-ETH. Mode to “Direct” in Connect-Network setting (default).
2. Connect the camera to a computer with an Ethernet cable.