Z-CAM Z CAM E2C - Page 35

2. Connect the camera to a router with an Ethernet cable, then connect the router to
the computer with Ethernet cable or Wi-Fi. (Note: Camera and PC should connect
to the LAN port of router, not WAN port)
3. Check the Connect – Network setting, and there will show the IP address of the
camera on ETH.IP item (e.g. 192.168.1.101) if the connection is OK.
4. Open a browser on the PC / Mac, type in the address:
http://192.168.1.101/www/index.html (192.168.1.101 is the IP address example on
step 3 above, please use the actual IP address of the camera. You will see the