Initial Setup
● Connect the monitor to a power outlet.
1. Press the POWER button on the monitor or to turn it on (The indicator will be blue).
2. Connect the relevant cable to the corresponding input on the monitor. The source will be
automatically detected.
3. To change between inputs, press the “Source” button to enter the source menu. Use the
“ ”and“ ” buttons to choose the input source between Auto Select, DP1, DP2, HDMI1 and HDMI 2.
Menu Options
● The menu for the monitor can be accessed by pressing the menu button on the control panel. This
menu is separated into the following sub menus: Picture Settings, Image Settings, Colour Temperature,
OSD Settings, Reset, and Miscellaneous options, details of each menu can be found in the following
section.
DP1
DP2
HDMI1
HDMI2
Shortcut Key Guide
● Activate the Signal Input Selection menu.Use and to navigate and M to select the source.
● Activeate the Line of Sight feature. Further press to cycle between the colors or turn off.
● Activeate the ECO Mode feature.Further press to cycle through the presets.
-11-
Note:
• The refresh rate will be up to 240Hz while using HDMI2/HDMI1/DP2/DP1 port.
To Next Page
Loading...
