Zanussi ZANZEAN11EW0 - User Manual

Zanussi ZANZEAN11EW0

20 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

GETTING

STARTED?

EASY.

User Manual

ZEAN11EW0

ZEAN11FW0

EN User Manual

Refrigerator

Questions and Answers

R
Richard CervantesAug 18, 2025
Why is my Zanussi ZANZEAN11EW0 not operating?
- K
  Kathryn LawsonAug 18, 2025
  Your Zanussi Refrigerator might not be operating because it is switched off. In this case, switch it on. Another reason could be that the mains plug is not correctly connected to the mains socket; make sure it is properly connected. Also, there might be no voltage in the mains socket. To check this, connect a different electrical appliance to the same socket. If it still doesn't work, contact a qualified electrician.
P
Peter YoungAug 21, 2025
How do I fix the lamp in my Zanussi ZANZEAN11EW0?
- P
  Patricia DavisAug 21, 2025
  The lamp in your Zanussi Refrigerator might not work because it is in stand-by mode. Try closing and opening the door. If that doesn't work, the lamp might be defective.
J
Jennifer HendrixAug 23, 2025
Why is my Zanussi Refrigerator so noisy?
- B
  burketimothyAug 23, 2025
  Your Zanussi Refrigerator might be noisy because it is not supported properly. Check if the appliance stands stable.
N
Nicholas HooverAug 26, 2025
What to do if there is too much frost and ice in my Zanussi ZANZEAN11EW0 Refrigerator?
- T
  Tara HunterAug 26, 2025
  Too much frost and ice in your Zanussi Refrigerator can be due to several reasons. The door might not be closed correctly, or the gasket could be deformed or dirty. Food products might not be wrapped properly. Make sure to wrap food products better. The temperature might be set incorrectly. Also, the appliance might be fully loaded and set to the lowest temperature; try setting a higher temperature. It could also be that the temperature set in the appliance is too low and the ambient temperature is too high; in this case, set a higher temperature.
K
kylie84Aug 28, 2025
Why is the temperature in my Zanussi ZANZEAN11EW0 too low or too high?
- C
  cbutlerAug 28, 2025
  The temperature in your Zanussi Refrigerator might be too low or too high because it is not set correctly; try setting a higher or lower temperature. The door might not be closed correctly. The food products' temperature might be too high; allow the food products' temperature to decrease to room temperature before storage. Also, many food products might be stored at the same time; try storing fewer food products at the same time. If the thickness of the frost is greater than 4-5 mm, defrost the appliance. The door may have been opened often, so open the door only when necessary. The Super Freeze function could be switched on.
S
Sean HendersonAug 31, 2025
Why is there too much condensed water on the rear wall of my Zanussi ZANZEAN11EW0?
- A
  Anthony StephensAug 31, 2025
  Too much condensed water on the rear wall of your Zanussi Refrigerator can occur if the door was opened too frequently; open the door only when necessary. It could also be that the door was not closed completely; make sure the door is closed completely. Another reason could be that stored food was not wrapped; wrap food in suitable packaging before storing it in the appliance.
D
Debbie Davis PhDSep 2, 2025
What to do if water flows on the floor from my Zanussi ZANZEAN11EW0?
- D
  darrellschneiderSep 2, 2025
  If water is flowing on the floor from your Zanussi Refrigerator, it is likely that the melting water outlet is not connected to the evaporative tray above the compressor. Attach the melting water outlet to the evaporative tray.
C
Charlene BakerSep 4, 2025
What to do if my Zanussi ZANZEAN11EW0 compressor operates continually?
- K
  Karen SmithSep 4, 2025
  If the compressor in your Zanussi Refrigerator is operating continually, it could be due to a few reasons. The temperature might be set incorrectly. Many food products might have been put in at the same time; wait a few hours and then check the temperature again. The room temperature might be too high. Food products placed in the appliance might have been too warm; allow food products to cool to room temperature before storing. The door might not be closed correctly. The Super Freeze function could be switched on.
J
Jeffrey MercerSep 7, 2025
What to do if water flows inside my Zanussi ZANZEAN11EW0 Refrigerator?
- J
  james09Sep 7, 2025
  If water is flowing inside your Zanussi Refrigerator, it could be because food products are preventing the water from flowing into the water collector; make sure that food products do not touch the rear plate. It's also possible that the water outlet is clogged; try cleaning the water outlet.
S
Samantha CarsonSep 9, 2025
What to do if water flows on the rear plate of Zanussi ZANZEAN11EW0?
- L
  Linda SmithSep 10, 2025
  If water flows on the rear plate of your Zanussi Refrigerator, it is because during the automatic defrosting process, frost melts on the rear plate. This is normal. You can dry the water with a soft cloth.

Zanussi ZANZEAN11EW0 Specifications

General

Appliance placement	Freestanding
Product colour	White
Door hinge	Right
Reversible doors	Yes
Number of compressors	1
Climate class	SN-N-ST-T
Noise level	39 dB
Number of vegetable drawers	1
Door balconies	3
Egg balcony	Yes
Bottle rack	Yes
Freezer net capacity	70 liters
Star rating	4*
Annual energy consumption	280 kWh
Width	595 mm
Depth	650 mm
Height	1860 mm
Number of Shelves	3
Defrost System	Manual
Freezer Star Rating	4*
Fridge number of shelves/baskets	3
Number of freezer shelves/baskets	3

Related product manuals

Preview: Zanussi ZT 75

Preview: Zanussi ZRT623W

Zanussi ZRT623W

Zanussi ZU63 TR

Zanussi ZBB5284

Preview: Zanussi ZBB3294

Zanussi ZBB3294

Preview: Zanussi ZBB6284

Zanussi ZBB6284

Zanussi ZBT3204

Preview: Zanussi ZBB 7266

Zanussi ZBB 7266

Zanussi ZUD 9154

Preview: Zanussi ZRB 29NA

Zanussi ZRB 29NA

Zanussi ZRB227WO

Preview: Zanussi ZBB 6286

Zanussi ZBB 6286