What to do if Zanussi ZDF36001WA program does not start?
If your Zanussi Dishwasher program doesn't start, first, ensure the door is fully closed. If a delay start is set, either cancel it or wait for the countdown to finish. Also, the appliance may be recharging the resin inside the water softener, which takes about 5 minutes.
What to do if Zanussi ZDF36001WA does not drain water?
If your Zanussi Dishwasher isn't draining water and the display shows an error, check that the sink spigot, outlet hose filter, and interior filter system aren't clogged. Also, make sure the drain hose isn't kinked or bent.
Why Zanussi ZDF36001WA Dishwasher does not fill with water?
If your Zanussi Dishwasher isn't filling with water and the display shows an error, make sure the water tap is open and the water supply pressure isn't too low. Check that the water tap and the filter in the inlet hose aren't clogged, and ensure the inlet hose has no kinks or bends.
Why Zanussi ZDF36001WA Dishwasher leaks from the door?
If you notice a small leak from the door of your Zanussi Dishwasher, the appliance may not be level. Try loosening or tightening the adjustable feet. Also, the appliance door might not be centered on the tub, so adjust the rear foot if needed.
Why Zanussi ZDF36001WA Dishwasher trips the circuit-breaker?
If your Zanussi Dishwasher trips the circuit-breaker, it could be due to insufficient amperage to supply all appliances in use simultaneously. Check the socket amperage and the capacity of the meter, or turn off one of the other appliances. Alternatively, there may be an internal electrical fault in the appliance.
What to do if Zanussi ZDF36001WA anti-flood device is on?
If the anti-flood device on your Zanussi Dishwasher is activated and the display shows an error, close the water tap.
Why Zanussi Dishwasher door is difficult to close?
If the door of your Zanussi Dishwasher is hard to close, the appliance may not be level. Try adjusting the feet. Also, tableware might be protruding from the baskets, obstructing the door.
Why Zanussi ZDF36001WA Dishwasher makes rattling sounds?
If your Zanussi Dishwasher makes rattling or knocking sounds, make sure the tableware is correctly arranged in the baskets. Also, ensure the spray arms can rotate freely.
Why Zanussi Dishwasher stops and starts during operation?
It is normal for the Zanussi Dishwasher to stop and start multiple times during operation. This provides optimal cleaning and saves energy.
General| Brand | Zanussi |
|---|---|
| Model | ZDF36001WA |
| Category | Dishwasher |
| Language | English |
To Next Page
