What to do if my Zanussi ZDI26022XA Dishwasher program does not start?
If your Zanussi Dishwasher won't start, ensure that the appliance door is fully closed. Also, if the delay start function is activated, either cancel the setting or wait until the countdown is complete. Additionally, the dishwasher may be undergoing a resin recharge, which typically lasts about 5 minutes.
Why is my Zanussi ZDI26022XA not filling with water?
If your Zanussi Dishwasher is not filling with water and the display shows an error, make sure the water tap is fully open. Check that the water supply pressure is adequate by contacting your local water authority. Also, inspect the water tap, the filter in the inlet hose, and the inlet hose itself to ensure they are free from clogs, kinks, or bends.
What to do if my Zanussi Dishwasher does not drain the water?
If your Zanussi Dishwasher won't drain water and the display shows an error, check to make sure the sink spigot is not clogged. Also, ensure that the filters in the outlet hose and the interior filter system are clear of any blockages. Finally, verify that the drain hose is free from any kinks or bends.
What to do if the anti-flood device is on in my Zanussi Dishwasher?
If the anti-flood device on your Zanussi Dishwasher is activated and the display shows an error, close the water tap and contact an Authorised Service Centre.
How to fix a small leak from the Zanussi Dishwasher door?
A small leak from the Zanussi Dishwasher door may indicate that the appliance is not levelled. Try loosening or tightening the adjustable feet. If the door is not centred on the tub, adjust the rear foot.
Why does my Zanussi ZDI26022XA Dishwasher trip the circuit-breaker?
If your Zanussi Dishwasher trips the circuit-breaker, it could be due to insufficient amperage to supply all appliances in use simultaneously. Check the socket amperage and the capacity of the meter, or turn off one of the appliances in use. If the issue persists, there may be an internal electrical fault in the appliance, and you should contact an Authorised Service Centre.
Why is Zanussi Dishwasher door difficult to close?
If your Zanussi Dishwasher door is difficult to close, make sure that the appliance is level by adjusting the adjustable feet. Also, check that parts of the tableware are not protruding from the baskets.
Why is my Zanussi ZDI26022XA Dishwasher making rattling noises?
If your Zanussi Dishwasher is making rattling or knocking sounds, it might be because the tableware is not properly arranged in the baskets. Refer to the basket loading leaflet for guidance. Additionally, ensure that the spray arms can rotate freely without obstruction.
Why does Zanussi ZDI26022XA Dishwasher stop and start during operation?
It is normal for the Zanussi Dishwasher to stop and start multiple times during operation. This provides optimal cleaning results and energy savings.
Why does the remaining time increase on my Zanussi ZDI26022XA?
When the remaining time in the display of your Zanussi Dishwasher increases and skips nearly to the end of program time, this is not a defect. The appliance is working correctly.
General| Type | Built-in |
|---|---|
| Category | Dishwasher |
| Size | Full-size |
| Energy Efficiency Class | A++ |
| Place settings | 13 |
| Number of Programs | 6 |
| Delay Start | Yes |
| Annual Energy Consumption | 262 kWh |
| Drying Class | A |
| Half Load Option | Yes |
| Water Consumption | 9.5 L |
| Programs | Eco, Intensive, Quick |
To Next Page
