What to do if my Zanussi Dishwasher does not fill with water?
If your Zanussi Dishwasher isn't filling with water, check the following: * Ensure the water tap is fully open. * Contact your local water authority to verify the water supply pressure is adequate. * Make sure the water tap isn't clogged. * Inspect the filter in the inlet hose for clogs. * Confirm the inlet hose has no kinks or bends.
Why my Zanussi ZDI26001XA Dishwasher programme does not start?
If the Zanussi Dishwasher programme isn't starting, make sure the appliance door is properly closed. Also, if the delay start is set, either cancel the setting or wait for the countdown to finish. The appliance may also be recharging the resin inside the water softener, which takes approximately 5 minutes.
What to do if my Zanussi ZDI26001XA Dishwasher won't drain the water?
If your Zanussi Dishwasher is not draining water, check that the sink spigot isn't clogged and ensure the drain hose has no kinks or bends.
General safety precautions for household and similar applications, including installation and usage guidelines.
Guidelines for safe electrical connection, earthing, and socket usage.
Procedures for connecting the water supply, including hose safety and checks.
Guide to setting the water softener based on water hardness, including a reference table.
Solutions for appliance activation issues or programmes failing to start.
Solutions for when the appliance fails to fill with water, display shows /10.
Solutions for when the appliance fails to drain water, display shows /20.
Action to take when the anti-flood device activates, display shows /30.
General| Type | Built-in |
|---|---|
| Category | Dishwasher |
| Capacity | 13 Place Settings |
| Energy Efficiency Class | A++ |
| Noise Level | 44 dB |
| Wash Programs | 6 |
| Height | 82 cm |
| Width | 60 cm |
| Drying Class | A |
| Delay Start | Yes |
| Half Load Option | Yes |
| Programs | Eco, Intensive, Quick, Glass |
| Size | Full-size |
To Next Page
