Why is my Zanussi ZEAN82ER not working?
If your Zanussi Refrigerator isn't operating, first, ensure that the appliance is switched on. Next, check that the mains plug is correctly connected to the mains socket. Finally, verify that there is voltage in the mains socket by connecting a different electrical appliance or contacting a qualified electrician.
Why is water leaking from my Zanussi Refrigerator onto the floor?
If water is flowing on the floor from your Zanussi Refrigerator, it is possibly because the melting water outlet is not correctly connected to the evaporative tray. Ensure that the melting water outlet is attached to the evaporative tray, either above or below the compressor.
What to do if food products temperature is too high in Zanussi Refrigerator?
If the temperature of food products is too high in your Zanussi Refrigerator, ensure that you let the food products' temperature decrease to room temperature before storage. Avoid storing many food products at the same time. Defrost the appliance if the thickness of the frost is greater than 4-5 mm. Open the door only when necessary. Also, ensure that there is cold air circulation in the appliance.
Why does my Zanussi Refrigerator compressor run constantly?
If your Zanussi Refrigerator compressor operates continually, it could be due to several reasons. First, consult the 'Control panel' chapter to ensure the temperature is set correctly. If you recently added many food products, wait a few hours and check the temperature again. High room temperature could also be a factor, so refer to the 'Installation' chapter. Ensure food products have cooled to room temperature before storing them. Also, check that the door is closed correctly. Finally, check if the FastFreeze function is activated.
How to reduce frost and ice buildup in Zanussi ZEAN82ER?
If there's too much frost and ice in your Zanussi Refrigerator, refer to the 'Closing the door' section to ensure the door is closed correctly and that the gasket is not deformed or dirty.
Why is there water inside my Zanussi ZEAN82ER Refrigerator?
If water flows inside your Zanussi Refrigerator, ensure that food products are not preventing water from flowing into the water collector by making sure they do not touch the rear plate. Also, check if the water outlet is clogged and clean it if necessary.
What to do if Zanussi Refrigerator temperature is too low or high?
If the temperature in your Zanussi Refrigerator is too low or too high, set a higher or lower temperature. Also, refer to the 'Closing the door' section to ensure that the door is closed correctly.
How to fix Zanussi Refrigerator lamp not working?
If the lamp in your Zanussi Refrigerator does not work, first close and open the door to see if the lamp is in stand-by mode. If that doesn't work, contact the nearest Authorized Service Centre because the lamp is defective.
Why temperature cannot be set on Zanussi Refrigerator?
If the temperature cannot be set on your Zanussi Refrigerator, it may be because the FastFreeze function is currently active. You should manually switch off the FastFreeze function, or wait until the function deactivates automatically to set the temperature.
Why doesn't my Zanussi ZEAN82ER Refrigerator door open easily?
If the door of your Zanussi Refrigerator does not open easily, wait a few seconds between closing and re-opening the door.
General| Brand | Zanussi |
|---|---|
| Model | ZEAN82ER |
| Category | Refrigerator |
| Language | English |
To Next Page
