What to do if my Zanussi hob sensor fields become hot?
If the sensor fields on your Zanussi hob become hot, it may be because the cookware you're using is too large or is placed too close to the controls. If possible, place large cookware on the rear zones.
Why the residual heat indicator does not come on Zanussi ZEI6632FBA Hob?
The residual heat indicator might not illuminate if the zone hasn't been hot enough, because it operated only for a short time. If the zone operated sufficiently long to be hot, speak to an Authorised Service Centre.
Why does the heat setting change between two levels on my Zanussi ZEI6632FBA?
The heat setting on your Zanussi hob might be changing between two levels because the power management function is in operation. Refer to 'Daily use' chapter for more information.
Why I cannot activate my Zanussi ZEI6632FBA?
There are several reasons why you might not be able to activate your Zanussi hob: * The hob may not be correctly connected to the electrical supply. Ensure it is properly connected. * A fuse might be blown. Check the fuse and replace it if necessary. If the fuse blows repeatedly, consult a qualified electrician. * You may have touched multiple sensor fields simultaneously. Touch only one sensor field at a time. * There might be water or fat stains on the control panel. Clean the control panel thoroughly. * Try to activate the hob again and set the heat setting in less than 10 seconds.
What to do if my Zanussi Hob deactivates?
If your Zanussi hob deactivates, it could be due to an object being placed on the sensor field. Remove any objects from the sensor field.
What to do if my Zanussi ZEI6632FBA Hob is beeping and deactivates?
If your Zanussi hob is emitting an acoustic signal and deactivating, it's likely because something is placed on one or more of the sensor fields. Remove the object from the sensor fields.
What to do if Automatic Heat Up function does not operate on my Zanussi ZEI6632FBA Hob?
If the Automatic Heat Up function on your Zanussi hob isn't working, it could be because: * The zone is already hot. Allow the zone to cool down sufficiently. * The highest heat setting is already set. The highest heat setting provides the same power as the Automatic Heat Up function.
General| Hob type | Induction |
|---|---|
| Product Type | Induction Hob |
| Number of Cooking Zones | 4 |
| Colour | Black |
| Control Type | Touch Control |
| Power Levels | 9 |
| Boost Function | Yes |
| Residual Heat Indicator | Yes |
| Timer | Yes |
| PowerSlide Control | No |
| Installation Type | Built-in |
| Surface Material | Glass |
| Dimensions (W x D) | 59 x 52 cm |
| Safety Features | Child Lock |
| Total Power | 7400 W |
To Next Page