Zanussi ZFV316K - User Manual

Need help?

Do you have a question about the Zanussi ZFV316K and is the answer not in the manual?

Overview

Function Description
Important Technical Specifications
Usage Features
Maintenance Features

This document is a user manual for the Zanussi ZFV316K Cooker Hood, providing instructions for its operation, maintenance, and safety.

Function Description

The Zanussi ZFV316K is a cooker hood designed to extract cooking fumes, odors, and steam from the kitchen. It features multiple motor speeds and a lamp to illuminate the cooking surface, enhancing visibility and comfort during cooking. The hood is intended to be used above a cooking hob or range.

Important Technical Specifications

The manual indicates that the appliance is supplied with an LED lamp and a separate control gear (LED driver). These components are designed to be replaced by a qualified technician only in case of malfunction. The specific power consumption or extraction rates are not detailed in this excerpt but are implied by the different motor speeds.

Usage Features

The cooker hood is operated via a control panel with four buttons:

Lamp (1): Activates or deactivates the cooking surface illumination.
First motor speed / Off (2): Turns the appliance on at the first speed setting or turns it off if already on.
Second motor speed (3): Activates the second motor speed.
Third motor speed (4): Activates the third motor speed.

The manual provides guidance on selecting the appropriate motor speed based on cooking activity:

First speed (Vol1): Recommended for heating up food or cooking with covered pots.
Second speed (V): Suitable for cooking with covered pots on multiple cooking zones or burners, or for gentle frying.
Third speed (V): Ideal for boiling, frying large quantities of food without a lid, or cooking on multiple cooking zones or burners.

It is recommended to operate the hood for approximately 15 minutes after cooking to ensure complete extraction of fumes.

Maintenance Features

The manual outlines two primary maintenance tasks: cleaning the grease filter and replacing the charcoal filter.

Cleaning the Grease Filter:

Frequency: Each grease filter must be cleaned at least once a month.
Procedure:
1. Press the handle of the mounting clip on the filter panel underneath the hood.
2. Slightly tilt the front of the filter downwards and pull it out.
3. Clean the filters using a sponge with non-abrasive detergents or in a dishwasher.
Dishwasher Use: If using a dishwasher, it should be set to a low temperature and a short cycle. The manual notes that the grease filter may discolour, but this does not affect its performance.
Reinstallation: To mount the filters back, follow the removal steps in reverse order. This process should be repeated for all filters.

Replacing the Charcoal Filter:

Frequency: The saturation time of the charcoal filter varies depending on cooking type and the regularity of grease filter cleaning.
Warning: The charcoal filter is NON-washable and cannot be regenerated.
Procedure:
1. Remove the grease filters from the appliance (refer to the "Cleaning the grease filter" instructions).
2. Turn the charcoal filter counterclockwise and then pull it out.
Reinstallation: To mount the new filters back, follow the removal steps in reverse order.

Replacing the Lamp:

The appliance is equipped with an LED lamp and a separate control gear (LED driver).
These parts can only be replaced by a technician. Users are advised to refer to the "Service" section in the "Safety Instructions" chapter for malfunction guidance.

Environmental Concerns: The manual encourages users to recycle packaging materials and waste electrical and electronic appliances. Products marked with the symbol should not be disposed of with household waste but returned to a local recycling facility or municipal office.

The manual also emphasizes the importance of reading the separate Installation Instructions booklet for Safety Information and Installation before any use or maintenance of the appliance.