What to do if my Zanussi ZTAN14FS1 does not operate?
If your Zanussi Freezer isn't operating, first, ensure the appliance is switched on. Then, check if the mains plug is correctly connected to the mains socket. If it still doesn't work, test the socket with another appliance; if there's still no power, contact a qualified electrician.
Why is there too much frost and ice in my Zanussi ZTAN14FS1?
Too much frost and ice in your Zanussi Freezer can be caused by several factors. Ensure the door is closed correctly. Make sure food products are wrapped properly. If the appliance is fully loaded and set to the lowest temperature, set a higher temperature. If the temperature set in the appliance is too low and the ambient temperature is too high, set a higher temperature.
What to do if temperature setting LEDs flash at the same time on my Zanussi ZTAN14FS1 Freezer?
Contact the nearest Authorised Service Centre. The cooling system will continue to keep food products cold, but temperature adjustment will not be possible.
Why is the temperature in my Zanussi ZTAN14FS1 too high or too low?
The temperature in your Zanussi Freezer might be too high or too low because it is not set correctly, so set a higher or lower temperature. Other possible causes are: the door is not closed correctly; the food products' temperature is too high, so let the food products temperature decrease to room temperature before storage; many food products are stored at the same time, so store less food products at the same time; the thickness of the frost is greater than 4-5 mm, so defrost the appliance; the door has been opened often, so open the door only if necessary.
Why is water flowing on the floor from my Zanussi ZTAN14FS1 Freezer?
If water is flowing on the floor from your Zanussi Freezer, it's likely that the melting water outlet isn't correctly connected to the evaporative tray above the compressor. Attach the melting water outlet to the evaporative tray to fix this.
Why doesn't the door of my Zanussi ZTAN14FS1 Freezer open easily?
If the door of your Zanussi Freezer doesn't open easily, especially right after you've closed it, wait a few seconds before trying to reopen it. This allows the pressure to equalize.
Why does the compressor operate continually in my Zanussi ZTAN14FS1?
If your Zanussi Freezer compressor runs continually, it could be due to a few reasons. Check if the temperature is set correctly. If you've just added a lot of food, give it a few hours to stabilize. Ensure food has cooled before storing it. Also, make sure the door is closing properly.
Why temperature cannot be set on my Zanussi Freezer?
You cannot set the temperature on your Zanussi Freezer because the "FastFreeze function" is switched on. Switch off "FastFreeze function" manually, or wait until the function deactivates automatically to set the temperature.
To Next Page
General
