First: We have the DSP6-SL. This is a stand alone Digital Signal
Processor that combines all the functions of an entire array of Zapco
processing into a single compact device. We’ve even added functions never
before available from Zapco processors. The DSP6-SL is programmed and
controlled by a PC through a custom Zapco program designed to be both
full functioned and easy to use.
Second: We’ve developed an entire line of Reference Digital amps,
which have all the DSP6-SL functions on-board. You can just hook up your
Reference Digital amp and play music, or you can add the program to your
PC and have full control of all functions to customize your amp to your
needs.
Third: We have developed the DRC-SL in-dash remote that will allow
you to have immediate 24/7 real time access to your programming right from
your dash.
And, perhaps most significant of all, the Zapco Digital Programming
Network. The network will allow you to control up to 16 amplifiers from a
single DRC-SL or PC. Every Digital series component has a USB port to
allow you to enter the network at any node position and control every
component on the network.
No, Zapco is not the first to put a DSP in a product.
What history will remember though, is that Zapco was the first to do it right.
Welcome to the World of Zapco Digital
In this manual we will take you through the programming and control
functions of the DRC6-SL and the on-board DSP in the Reference Digital
amps as well networking operations of Zapco’s DPN system.
To Next Page
Loading...
Need help?
General