- 14 -
STEP 2: Mount Fence Controller/Connect Ground
NOTE: B10LI does NOT need to mount in a waterproof enclosure
To other
ground rods
Check ground system reliability
• IMPROPER GROUNDING WILL AFFECT THE PERFORMANCE OF
YOUR FENCE CONTROLLER! See page 22 for more information
about proper grounding.
Ground rod clamp
(part no.07105-96 or CGR1)
Ground rod
(part no.07104-96 or GR8)
Tip: The fence controller must be grounded sufficiently for the
system to work effectively. Improper grounding can also cause inter-
ference on telephone lines, radios and television and could invalidate
your warranty.
The B10LI can mount on a rod
post or directly on a ground rod.
If additional ground rods are
needed, connect hook-up wire to
GROUND terminal.
1½“
Strip 20KV hook-up wire and
connect as shown
To Next Page
Loading...
