ZCS 7000-BE-24 - User Manual

43 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

Solo documento principale.

Identification: MD-AL-GI-00

Rev. 4.0 of 31.01.18 - Application: GID

Pile Reg. IT12110P00002965 - Share Capital € 100,000.00 fully paid up

AR Bus. Reg. no. 03225010481 – AR REA no. - 94189

Certified Company ISO 9001 - Certificate no. 9151 - CNS0 - IT-17778

Zucchetti Centro Sistemi S.p.A. - Green Innovation Division

Via Lungarno, 248 - 52028 Terranuova Bracciolini - Arezzo, Italy

tel. +39 055 91971 - fax. +39 055 9197515

innovation@zcscompany.com - zcs@pec.it - zcsazzurro.com

Manual of 25/08/2020 Rev. 1.2 “User Manual 7000-BE-24”

1/43

AC charging station for electric vehicles

7000-BE-24

User Manual

Table of Contents

Questions and Answers

D
Debbie SweeneyAug 11, 2025
What to do if my ZCS 7000-BE-24 shows input overvoltage?
- B
  Brittany WrightAug 11, 2025
  If the ZCS Battery Charger shows an input overvoltage error, it means the AC input voltage is too high. First, check the input voltage from the back-end. If the voltage remains higher than 264Vac for a short while, allow time for the grid to restore a suitable voltage level.
L
Lawrence DavisAug 20, 2025
What to do if my ZCS 7000-BE-24 Battery Charger displays input overcurrent?
- K
  kyle81Aug 20, 2025
  If the ZCS Battery Charger displays an input overcurrent error, it indicates that the AC input current is too high. You should check for a low resistance connection between the charger cable's AC outputs. Also, immediately switch off the circuit breaker for the leakage current of the power distribution.
C
chelsea92Aug 31, 2025
What to do if my ZCS 7000-BE-24 shows input undervoltage?
- M
  Mary HernandezAug 31, 2025
  If the ZCS Battery Charger is showing an input undervoltage error, it means the AC input voltage is too low. To solve this, check the input voltage from the back-end.

ZCS 7000-BE-24 Specifications

General

Output Voltage	24VDC
Cooling Method	Forced Air Cooling
Protection Features	Over voltage, over current, short circuit, over temperature
Humidity	5% to 95% (non-condensing)
Input Voltage	100-240VAC, 50/60Hz