9
Adjusting the Side Panels
1. Using two coins, unscrew the plastic barrel-screw fasteners.
2. Move the side panel to different set of grommets on vest and re in stall.
Fitting and Assembly
3. Note that one extra plastic barrel-screw is installed in an unused
grommet hole when the BCD leaves the factory. This extra screw can be
used if one is lost.
NEVER breathe from the bladder assembly. The bladder as-
sem bly was not designed as an auxiliary air source and may
contain harm ful con tam i nants, which if inhaled, may cause
in ju ry or death.
To Next Page
Loading...
