16
Pre-dive Assembly and Inspection
Weight System Inspection
Check to see that weight release system is secure.
Ripcord ™ release system - check bottom of weight pockets to be sure
they are held closed by the ripcord. If the Ripcord
has been pulled, re-
thread the system. (Refer to the re-threading section on following page).
Check to see that weight release system is secure.
ZIP Touch™ fastener pocket system - Check to see that the Velcro
touch fastener material fl ap on the bottom of each weight pocket com-
plete ly overlaps and is secure.
To Next Page
Loading...
