TC56/TC57 Vehicle Cradle Installation Guide
13
Inserting and Removing the TC56/TC57
NOTE: The vehicle cradle only supports the insertion and charging of a
TC56/TC57 with a standard Zebra Technologies battery in the device’s
protective boot (SG-TC5X-EXO1-01).
CAUTION: Do not leave the device in the cradle in direct sunlight for a long period of time
as it may cause the device to exceed proper operating temperature, overheat, or UV rays
may lessen the life of the touch panel.
To insert the TC56/TC57 in the vehicle cradle:
1. Insert the TC56/TC57 in the vehicle cradle in a vertical position, and push
down until the Release Latches click and the device is secured in place.
Figure 11 Insert TC56/TC57 in Vehicle Cradle
To ensure the TC56/TC57 is inserted correctly, listen for the audible click that
signifies that the TC56/TC57 button release locking mechanism is enabled and
the TC56/TC57 is locked into place.
To Next Page
Loading...
