TC56/TC57 Vehicle Cradle Installation Guide
7
Mounting to a Windshield
CAUTION: Do not install a vehicle cradle on or near an air bag cover plate or within an
aerobic zone. Also, do not install it in a location that affects vehicle safety or drivability.
1.
Fix the RAM Mount to the selected area.
Figure 5 Mounting to a Windshield
2. Twist the lever on the RAM Mount suction cup base to create a vacuum
between the suction cup and the windshield.
CAUTION:
To prevent suction cups from falling off the windshield due to
bleeding air over
time and with extreme heat:
1) Ensure the glass and the suction cup are completely clean and free of oils and debris
before installing.
2) Periodically remove, clean, and re-seat the suction cup on the glass (more frequently
in the summer and hot, sunny climates).
3.
Adjust the vehicle cradle in a vertical position and ensure that the suction
bond is strong enough before installing the device.
4. To connect power, see Connecting Power on page 9.
5. To insert the device, see Inserting and Removing the TC56/TC57 on page 13.
To Next Page
Loading...
