TC56/TC57 Vehicle Cradle Installation Guide
8
Mounting to a Dashboard
CAUTION: Do not install a vehicle cradle on or near an air bag cover plate or within an
aerobic zone. Also, do not install it in a location that affects vehicle safety or drivability.
1.
Fix the RAM Mount to the selected area.
NOTE: Ensure that the installed vehicle cradle does not rest on the dashboard
or other structure that can transmit the vehicle vibrations that would normally
be reduced by the suction cup.
Figure 6 Mounting to a Dashboard
2. Twist the lever on the RAM Mount suction cup base to create a vacuum
between the suction cup and the dashboard.
3. Adjust the vehicle cradle in a vertical position and ensure that the suction
bond is strong enough before installing the device.
4. To connect power, see Connecting Power on page 9.
5. To insert the device, see Inserting and Removing the TC56/TC57 on page 13.
To Next Page
Loading...
