Zebra Z4M - Fanfold Media Loading

Page 2-6 Z4M/Z6M Maintenance Manual 77259L Rev. 4 12/16/03
6HFWLRQ 2SHUDWLRQV2YHUYLHZ
3. Slide out the media guide as far from the printer frame as possible.
4. Place the roll of media on the media supply hanger.
5. Flip up the media supply guide. Slide in the media supply guide so that it just
touches, but does not restrict, the edge of the roll.
6. Feed the media under the dancer, through the slot in the transmissive sensor, under
the ribbon sensor, and out the front of the printer.
7. Ensure that the media is against the back of the transmissive sensor. Slide in the
media guide so that it just touches, but does not restrict, the edge of the media.
8. Close the printhead assembly.
Figure 2-3. Media Loading Tear Off Mode
Printhead Open Lever
Printhead
Assembly
Media Supply Guide
Media Guide
Media
Supply
Hanger
Ribbon
Sensor
Transmissive
Sensor