Zebra Z4M - Page 33

77259L Rev. 4 12/16/03 Z4M/Z6M Maintenance Manual Page 2-7
2SHUDWLRQV2YHUYLHZ 6HFWLRQ
Cutter Mode
(Cutter option required)
Refer to Figure 2-4.
1. Press the printhead open lever. The printhead assembly springs up.
2. Flip down the media supply guide.
3. Slide the media guide out as far from the printer frame as possible.
4. Place the roll of media on the media supply hanger.
5. Flip up the media supply guide. Slide in the media supply guide so that it just
touches, but does not restrict, the edge of the roll.
6. Feed the media under the dancer, through the slot in the transmissive sensor, under
the ribbon sensor, and through the cutter module.
7. Ensure that the media is against the back of the transmissive sensor. Then, slide in
the media guide so that it just touches, but does not restrict, the edge of the media.
8. Close the printhead assembly.
Figure 2-4. Media Loading Cutter Mode
Printhead Open Lever
Printhead
Assembly
Media Supply Guide
Media Guide
Media
Supply
Hanger
Ribbon
Sensor
Transmissive
Sensor