Zebra ZD500 series - Page 49

37
Setup
Configure Using the Connectivity Wizard
1/16/2014 ZD500 Series™ Thermal Transfer Printer User’s Guide P1062653-002 Rev. A
8. Enable the DHCP (dynamic) or static IP option.
9. Click Next.
The Wireless Settings window opens.
10. Enter the ESSID.
If you will be using... Complete the following steps...
DHCP a. Select DHCP and click Next.
b. Continue with step 9.
Static
a. Select Static.
The IP settings fields are activated.
a. Enter the IP Address, Default Gateway, and Subnet
Mask for the wireless print server. Contact your network
administrator for the correct values.
b. Continue with step 9.
Important • The ESSID and pass phrase, if used, must be set at your access point before
completing these steps.