Zebra ZD500 series - Page 60

Setup
Bluetooth Option Configuration
48
P1062653-002 Rev. A ZD500 Series™ Thermal Transfer Printer User’s Guide 1/16/2014
7. Check the printer’s display for the following screen. Verify that the pairing numbers
match.
If the numbers match, then press the ‘Next button’ in the ‘Add a device’ window and
then press the OK/Check Mark button on the printer’s control panel.
If the numbers do not match, use the printer’s control panel arrow keys to change the
highlighted ACCEPT to REJECT and then press the OK/Check Mark button on the
printer’s control panel.
8. When the paring process successfully completes, the following message will be displayed.
Note • Note the COM port number displayed in the task bar pop-up. It will only remain for a
few seconds.