Zebra ZP 450 - Page 24

Getting Started
Printing a Test Label
14
P1031442-001 ZP 450 User Guide 12/8/2010
Printing a Test Label
Before you connect the printer to your computer, make sure that the printer is in proper
working order.
You can do this by printing a configuration label.
1. Make sure the media is properly loaded and the top cover of the printer is closed. Then,
turn the printer power on if you have not already done so.
2. When the status light is solid green, press and hold the feed button until the status light
flashes once.
3. Release the feed button. A configuration label will print.
If you cannot get this label to print, refer to Getting Started on page 7.