Zebra ZP 450 - Universal Serial Bus (USB) Interface

Universal Serial Bus (USB) Interface
60
P1031442-001 ZP 450 User Guide 12/8/2010
Universal Serial Bus (USB) Interface
The figure below displays the cable wiring required to use the printer’s USB interface.
The printer requires cable or cable packaging that bears the “Certified USB™” mark to
guarantee USB 2.0 compliance.
For printer supported operating systems and drivers, see the software and documentation CD
or visit the Zebra Web site at:
http://www.zebra.com
For information on the USB interface, go to the USB web site at:
http://www.usb.org
Pin Signal
1Vbus - N/C
2D-
3D+
4Ground
Shell Shield / Drain Wire
1
2
3
4