Zebra ZP 500 - Complete Setup (cont.); Set Default Printer and Test

Quick Installation Guide 8
ZP 500 Plus Thermal Printer
Step 6: Complete Setup (cont.)
At the bottom of the screen in the section labeled Set Default 5.
Printers, click the printer icon next to the Label Printer field.
Select the ZP 500 thermal printer driver you just installed and
click OK.
Click 6. OK to exit System Settings. To verify that the printer is
properly configured, click Utilities from the tool bar and select
Printer Setup. The label printer you just installed should
display in the Label Printer section. If not, select the label
printer from the drop-down menu. Click Test Printer and then
click OK.
Now you can begin printing using your ZP 500 Plus
Thermal Printer. Thank you for choosing FedEx.