Zeegma Handig - Installation Steps; How to Iron

EN
How to install:
1. Set the water tank lock buon (6) in the posion allowing unlocking the tank.
Remove the tank, pull downwards. Pour a suitable amount of water in, and then
put the tank back on. Switch the lock key to lock the water tank again .
2. Supply power to the device and press ON/OFF key (8), the light should go on.
The steamer will start heang up. Aer forty seconds, the device will be ready
for operaon.
3. Pressing the power buon again will control the steam released.
Three levels of adjustment are possible:
MAX (red) approx. 30 g
MEDIUM (blue) approx. 25 g
MIN (green), approx. 20 g
4.
When the steamer heats up, do not press the steam acvator (3). You can do
so aer the heang up has nished. If the process has been nished, press this
buon – the steam will be released. If you take your nger away, steam will not
be released. You can cause the steam to be generated connuously – to do so,
press the key and slide it downwards (4).
5. You can connect the product to the water bole instead of water tank.
How to iron:
The steamer is designed to iron and freshen up creased clothes, drapes, as well as
decorave items. It is safe for most fabrics.
Note!
Before you start ironing, check labels and suggesons on cleaning and maintenance. Make
sure the manufacturer of the fabric you wish to iron does not prohibit steam ironing.
Note!
The dish is suitable for use with clothes hung vercally or arranged horizontally. When
ironing horizontally, make sure that the end of the hose in the tank is immersed in
water
1. Check if the fabric used to manufacture the clothing is permeable so that steam
does not accumulate on it and does not dampen it.
2. Check pockets in the clothes you wish to iron and make sure there are no items
le.