Zendure AB1000 - Wichtige Tipps; Getting Started; Setup and Connection

3
It is recommended to use this product in an environment at
15℃ ~30℃ , away from water, re and other sharp objects.
For long-term storage, please charge and discharge this product once
every 3 months. That is, discharge the product to 30% rst, and then
recharge it to 60%.
If the power of this product is lower than 1% after use, please charge
it to 60% before storing it. Leaving the battery discharged for a long
time can cause irreversible damage to the battery and shorten the
service life of the product.
Do not disassemble the product. When service or repair is required,
please consult ofcial Zendure channels. Improper disassembly or
reassembly may result in a risk of re or personal injury.
4. Wichtige Tipps
60%
Add-on Battery AB1000
User Manual
the bottom
AB1000 Battery Port
Connect with PVHub or AB1000 Battery
Connect with AB1000 Battery
5. Getting Started
5.1 What’s in The Box
5.2 Product Overview
5.3 Connect with PVHub
1
1
2
2
PVHub can be connected to an AB1000 for capacity expansion. A Battery
Cable (not included) is needed. Refer to the user manual of the PVHub for
detailed instructions.
EN