Zendure Smart Meter CT - Safety Instructions

3
3. Safety Instructions
Name Smart Meter CT
Model ZDSMCT
Weight ≈ 181g
Dimensions 140 x 35 x 77mm
Rated System Voltage 100~240Vac
Frequency 50/60Hz
Consumption <1.1W
Max Measurement per Channel 150A
Ingress Protection IP44
Operating Temperature -20 ° C ～ 70 ° C （-4 ° F ～ 158 ° F）
Storage Temperature -40 ° C ～ 85 ° C (-40 ° F ～ 185 ° F)
Operating Humidity 5% ～ 95%
Max Operating Altitude 3000m / 9840ft
Wireless Type Bluetooth, Wi-Fi
1. The product should be installed by a qualied electrician.
2. Before operating, check if the Smart Meter CT or its cables are damaged or cracked.
If any damage is found, stop using the product immediately and contact Zendure
support.
3. Do not allow unauthorized personnel to replace internal components. This action
voids the warranty, and any related safety risks are solely the user's responsibility.
4. Install the product according to the user manual to prevent injury or product
damage.
5. Ensure that the service panel is disconnected before installation.
6. Do not install or operate the product outdoors, expose it to moisture, or submerge
it in liquid. Clean the ports with a dry cloth only.
7. Do not use the product if it is damaged or appears to be damaged. Do not
disassemble the product. Consult ofcial Zendure channels for service or repair.
Incorrect disassembly or reassembly may pose a re risk or cause injury.
8. Adhere to all local and national safety regulations for installation and use.
9. This product is intended solely for residential use, and any use in non-residential
settings may void warranties and pose safety risks, for which the manufacturer
assumes no liability.
10. Keep out of reach of children and pets.
EN