Zenith C27V22 Operating Guide And Warranty

Your Zenith TV may be connected to a
Super-VHS VCR through the S-Video Input
located on the front or rear source connec-
tion panels on your TV
Hook up your S-VHS VCRto your Zenith TV
according to the diagram shown at the right,
Remove the back of the remote and put in two
"AAA" batteries.
//
• x::xx:xxc:::x:%i ;
i From Antenna or
Cable Service With
Fiat Wire_
300/75 ohm
Adapter
............................... i•-]
VCR Back
Hug in your TV. Do not plug it into a switched
outlet. Your Zenith TV is designed to operate on
standard household current, 120-volt 60 Hertz
AC. Do not attempt to operate it on DC power.
120 VA_
60 Hz
On the remote, press SOURCErepeatedly until
"S-Video" is displayed. Or use the Source menu
to choose the S-Video input the equipment is
connected to.
ANTENNA
CABLE
TVBack
; 2
• VIDEO I
IN
S-VIDEO I
-@
@
.L@
_ NONO
Connect your S-Video VCRto the
S-Video i or S-Video 2 set of input jacks
J
•VIDEO_ -MONITORI
IN OUTPUT ]
S-VIDEO 2
VIDEO VIDEO 1
AUDIO AUDN ]

Zenith C27V22 Specifications

General

Brand	Zenith
Model	C27V22
Category	Monitor
Language	English