As indicated before, for security reasons, the communication between IWAC and
Securel v2 is encrypted.
Both IWAC and Securel v2 are connected to the KNX bus.
The data used by the system to allow or deny the access are:
Groups: sets of users or cards with the same access level. The groups
available are:
➢ Guest
➢ Visitor
➢ Staff
➢ Management
➢ Service
➢ Cleaning
➢ Maintenance
➢ Security
Card Identifier: unique NFC card identifier.
IWAC Display v3 Identifier: unique IWAC Display v3 identifier.
When recording data access to a card, the Z-Access application offers two alternatives
to the employee:
Associate the card with a specific group: the identifier of the selected
group will be recorded in the card. This option only supports DESFire cards.
Associate the card with a specific IWAC Display v3: the identifier of the
IWAC Display v3 will be recorded in the card (see section 2.5). Any card
associated with a specific IWAC Display v3 will be also associated with the
group “Guest”.
Any IWAC Display v3 has a unique identifier set by parameter. And it will gran or deny
the accesses according to its lists:
White list: groups with access granted. This list is set by parameter (see
section 2.5). In addition, IWAC Display v3 allows access to all the cards
associated with its identifier.
To Next Page
Loading...