Zennio IWAC - Page 6

IWAC Display v3
http://www.zennio.com
Technical Support: http://support.zennio.com
6
Black list: groups or cards with access denied. This list is set in Z-Access
and transmitted to IWAC Display v3 through the KNX bus.
The black list takes precedent over the white list (see examples below).
Note: an IWAC Display v3 that has the "Guest" group in its white list will allow access
to any card associated with any specific IWAC Display v3, so it is a configuration
intended for access control of common areas.
Examples:
Card 1
IWAC 124
Group “Guest”
IWAC 124
White list:
Black list:
IWAC 245
White list: Cleaning
Black list:
IWAC Gym
White list: Guest, Staff
Black list: Card 2
Card 2
IWAC 245
Group “Guest”
Card 3
Group “Cleaning”
Card 4
Group “Staff”
Card 1  Access granted
Card 2  Access denied
Card 3  Access denied
Card 4  Access denied
Card 1  Access denied
Card 2  Access granted
Card 3  Access granted
Card 4  Access denied
Card 1  Access granted
Card 2  Access denied
Card 3  Access denied
Card 4  Access granted
The spa is temporarily restricted to
guests by putting the group on the
black list:
Card 1  Access denied
Card 2  Access denied
Card 3  Access granted
Card 4  Access denied
IWAC Spa
White list: Guest, Cleaning
Black list: Guest
IWAC Swiming pool
White list: Guest, Cleaning
Black list:
Card 1  Access granted
Card 2  Access granted
Card 3  Access granted
Card 4  Access denied