Installation Instructions
Installing the Anti-tip Bracket
1. Position anti-tip bracket at a minimum of 8” from the left or right of the side of the
cooler.
2. Install anti-tip bracket to floor by using supplied 2” screws.
3. Push the cooler back into anti-tip bracket making sure the bracket overlaps the
cooler bottom.
Installing the Handle
1. Push aside the door gasket on the
side you wish to install the handle.
Under the gasket you will see two
designated holes for handle
installation and pre-installed screws.
2. Install the handle tightly as shown
with two screws, lock washers and
flat washers pre-installed.
To Next Page
Loading...
