Fixed Hoist Test Facility Operation and Maintenance Manual ZOM-12000-7 rev 0
Page 21 of 24
This manual contains proprietary information and is not to be copied or disclosed without written
permission from Zephyr International LLC. Copyright 2006-2008
Rescue Hoist FHTF Check List
Startup
1) Lower hanging hoist mount
2) Install hoist
a. Install electrical connectors and tighten
b. Insert (2) ¼ inch bolts or pins through one
side
3) Raise hanging hoist mount
a. Install two load bolts
b. Lower chain hoist to apply load to load cells
4) Connect Control Boxes
5) Connect Pendant
6) Move mobile GSE into position beneath hoist
7) Push Circuit Breaker Switch - on
8) Turn Indicator switch – on
a. Zero the load reading if necessary
9) Lower wire rope and hook with pendant control
10) Attach wire rope and hook to mobile GSE
11) Operate mobile GSE per instruction
To Next Page
Loading...
Need help?
General