8
1. Clean and disinfect the component and spray nozzle medication cup before each use.
2. Inject the liquid: Open the cap by turning it counterclockwise, inject the solution and return the cap
by turning it clockwise.
Note: Do not exceed the maximum capacity of 10 ml of the liquid. After injecting the liquid, do not
open the liquid cup lid, so as not to spill liquid.
Note! Add the liquid before turning
on the device.
The nozzle is a disposable accessory, max. reusable time is up to3times. It is only for single person
use and can’t be shared, to avoid cross-infection.
4.5 Nebulization
1) Connect mask or mouthpiece, click " " to switch power on, start nebulization.
2) It starts withamedium spray rate, and spray rate can be adjusted by pressing "+"&"-" as needed.
3) This device also has a microwave mode in which the spray rate is changed automatically with the
breathing. After the device is started, long press " " button for 3s (when the blue light flashes 3
times) to switch to the microwave mode.
4) After switching to the surge mode, press and hold the " " button for 3s, or press "+" or "-" to switch
back to uniform mode.
5) Boot before atomization, shake slightly for full contact of the solution with atomizer. Use the following
three ways of inhalation according to individual needs.
To Next Page
Loading...
Need help?
General