EasyManua.ls Logo

Zero Appliances GFR260DB - Installation Instructions; User and Installer Guidelines; Appliance Positioning and Leveling

Zero Appliances GFR260DB
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
Author: Rudi Version: 2.1 Revision: 1.2 Revision Date: June 2019
INSTALLATION INSTRUCTIONS:
IMPORTANT INFORMATION FOR THE USER
Only a registered LP Gas installer may install a gas installation. All registered installers
are issued with a card carrying their registration number. Ask to be shown the card before
allowing the installation work to commence and make a note of the Installer QCC number.
Upon completion of the installation, the installer is required to explain the operational
details of the installation together with the safety instructions. You will be asked to sign
acceptance of the installation and be provided with a completion certificate. You should
only sign for acceptance of the installation when the installation is completed to your
satisfaction.
Note: Your invoice is required in the event that you wish make a guarantee claim.
IMPORTANT INFORMATION FOR THE INSTALLER.
An LP gas installer registered with the Liquefied Petroleum Gas Association of South
Africa only may install a gas installation. The installation must be installed in accordance
with the requirements of SANS 10087-1 and any fire department regulations and/or local
bylaws applicable to the area. If in doubt, check with the relevant authorities before
undertaking the installation. Upon completion of the installation, you are required to fully
explain and demonstrate to the user the operational details and safety practices applicable to
the installation and the appliance.
1. ENSURE THAT THE APPLIANCE IS STANDING LEVEL!
If positioning on uneven or soft ground, place two flat pieces of wood or
suitably hard material (approximately 600mm long and 100mm wide by
20mm thick) under the two feet of the appliance, from front to back, before
attempting to level the appliance.
2. Place the appliance in a cool, well-ventilated area out of direct sunlight and
strong gusts of wind, allow enough space (at least 100mm) around sides
and back of appliance and 600mm above.
3. Remove all loose items from appliance
IMPORTANT: There must be adequate space to reach the controls situated at the
back of the appliance easily.