5
Author: Rudi Version: 2.1 Revision: 1.2 Revision Date: June 2019
5. Do not smoke while checking for leaks.
6. Do not check for leaks with an open flame.
7 If the odour persists, contact your dealer or gas supplier immediately.
Do not store or use gasoline or other flammable vapor and liquid in the vicinity of
this or any other appliance.
USER OPERATING INSTRUCTIONS
TO START ELECTRIC OPERATION
1. Make sure that the gas supply to the appliance is turned off.
2. Plug in the electrical plug.
Note: Appliance cannot be run off two heat sources at the same time.
TO START GAS OPERATION
1. Make sure that the electrical supply to the appliance is turned off.
2. Open the shut-off valve for the gas bottle or gas installation (check that there is
enough gas).
3. Open flap B.
4. Keep the flame failure device knob (A) pressed in for approximately 5 seconds
to allow gas to flow to the burner.
5. Strike a match and insert into flap hole (B). While the flame is burning press
and hold the flame failure device for a further 10 seconds. The burner will now
burn with a blue flame.
6. If the flame goes out, repeat steps 4, 5 and 6 until the flame stays alight.
To Next Page
Loading...