Need help?Do you have a question about the Zeta Alarm Systems Infinite 8 and is the answer not in the manual?
Check system status, focusing on the green Power LED and any fault indicators.
Perform functional tests on call points/sensors, reset system, and check for obstructions.
Verify past repairs, inspect batteries, and confirm sounders operate on battery power.
Comprehensive check of all detectors, call points, sounders, and auxiliary equipment.
Conduct full wiring inspection and replace batteries due to their limited lifespan.
Overview of the panel's indicator lights displaying system status in normal operation.
Details how to access critical system controls via a secure code entry method.
Reference table for LED status indicators and their corresponding panel operational meanings.
Procedure to test all panel LEDs and the internal buzzer using the TEST button.
Explains how the panel signals a fire alarm using LEDs, internal buzzer, and sounders.
Instructions for silencing the alarm sounders after an event, using the access code.
Describes panel behavior when a new alarm zone is activated after sounders are silenced.
Procedure to manually activate sounders for building evacuation via the panel controls.
Steps to reset the panel after an alarm has been investigated and the cause cleared.
Details common fault types: General, Zone, Short Circuit, Power Supply, System, Earth, Sounder.
Indicates a fault on any part of the Fire Alarm System, often with other specific fault lights.
Signals a wiring issue within a specific zone or a detector removed from its base.
Detects a short circuit fault in zone or sounder circuits, affecting their operation.
Indicates mains failure or issues with the battery backup or charger.
Indicates panel microprocessor problems, possibly requiring a key switch reset procedure.
Detects a short circuit to earth on the wiring connected to any panel component.
Indicates a wiring fault on sounder circuits, potentially impacting sounder functionality.
Procedure for silencing fault buzzer, logging faults, and actions after fault rectification.
Temporary disabling of zones or sounders due to false alarm risks or specific conditions.
Step-by-step guide to temporarily disable specific zones or external sounders.
Procedure to re-enable previously disabled zones or external sounders.
Explains the purpose of delaying sounder activation to check alarm causes.
Details how sounder delays are programmed and can be activated/deactivated by the user.
Describes how the panel's LEDs indicate when a sounder delay is active.
Explains how the panel behaves during a fire alarm when a sounder delay is active.
Procedure to immediately activate sounders during a genuine fire alarm.
How to reset the system when an alarm is found to be false.
Steps to disable the active sounder delay feature on the panel.
Explains the utility of Zone Test for commissioning and maintenance checks.
Step-by-step guide to placing a specific zone into test mode.
Important considerations and limitations when using the Zone Test mode.
General| Brand | Zeta Alarm Systems |
|---|---|
| Model | Infinite 8 |
| Category | Control Panel |
| Language | English |
To Next Page
